This is a led bar for the Dronewolf Pup 2, made to fit the new standoffs and an Adafruit Neopixel 8 LED stick.

Designed to be very thin and light.

V2 uploaded, I made it easier to print in the vertical position and a bit more sturdier. Also, friendlier to 0.4mm nozzles, many of the walls are multiple of 0.4mm

V3 uploaded, the LED holder pushed back a few mm, now sits outside the frame to make room for a larger VTX or wires.

V4 is a slimmed down version of V3, less wide and elastic clips

History:
v1 - Initial design
v2 - Slimmer version, improved sturdiness and made it easier to print
v3 - Move the LEDs outside of the frame
v4 - Slim version

No

Yes

0.2mm

20%

Prints "face down" with supports in about 35 minutes at 30mm/s

If printing PLA, print at around 205 or 210 Celsius to get really good layer adhesion.