This is a mount for the BigTreeTech Eddy probe (both types), tailored specifically for the Sovol SV06 Plus. The mount does not utilize the screws supplied with the probe. Instead, it requires:

• 2x M3x20 (SHCS) or (BHCS) - either type fits
• 2x M3 hex nuts

It can be printed in PETG, but for better durability and heat resistance, ABS, ASA, or higher performance materials are recommended.

My print settings:

• 4 perimeters 
• 30% infill 

Probe offsets:

• X: 30 mm
• Y: -25 mm

Make sure to update your printer.cfg with the new offsets.

The probe works well with the Eddy-ng firmware. Calibration using a drive current of 16 for both TAP and mesh bed leveling works perfectly.