This easy to print makeup pad hanger allows to dry a reusable pad to dry before using the clean side. With a 0.2mm layer height it prints in less than an hour.

Printing

I recommend the following settings (for 0.2mm layer height):

• 3 Massive layers
• 20% Infill (Adaptive Cubic)
• 3 Perimeter

For the arm I recommend the following:

• 40% Infill
• 4 Perimeter
• Allow support

If your printer is more precise, you should consider scaling the arm up a bit, as the gap for the anchor cube is 0.2mm to allow less precise printers to produce good results, too.

Assembly

Depending on your printer I recommend using glue to combine the two parts. The gap for the anchor cube is 0.2mm, which should be enough clearanc to interlock for most printers. It may be too much if your printer is more precise.

Notes

There is a version with a smaller footprint, but it is too light and tends to be too wobbly when hanging the pad. With this version, the base is stable enough.