A seven egg egg roller holder- add to the top, take from the bottom, to make sure you use your eggs in the right order. Holds seven medium size eggs, so that's a box plus one left over from last week. Layers give the top an almost wood grain effect printed at 0.2 on Creality CR10S. Obviously we had to add our little robot logo on the front to add a bit of interest, will consider making a chicken version....

3D printer not running smoothly? Try these:

http://amzn.eu/9TkeApg PTFE grease for z axis screws
http://amzn.eu/a4ZVI64 Silicone Oil for bearing wheels

http://hagenautomation.com

Hagen Automation specialises in robotic automation solutions that are affordable. Covering a wide range of industries and applications from single, low cost robots to multi-machine solutions and integrated production lines.

Creality

CR-10S

No

No

0.2

20 percent triangles

Printed at 45 degree angle to the bed of our S4. We run our CR10 pretty slow, 40 max with 20 initial. Otherwise more or less standard Cura settings excepting ironing on, combing on no shell, and lines not concentric. Also temps at 210 nozzle and 60 bed for silver PLA. Would be good to try in a wood effect. Took about 7 hours. Needed the Crystal Grip to stop the print curling as it is pretty long and so could build tensions in the plastic. Probably not one for ABS as a result.

Did give it a quick rub down with scotchbrite to take off any little imperfections.