This is a Dial Indicator mount that snaps on the edge of a TAZ 3D printer FexiDually print head. It is similar to a mount that was shared here about a year ago. Although it does not measure the center of the print bed, it is very helpful in leveling the bed. It is designed to use a dial indicator from Harbor Freight.

LulzBot

TAZ 5

No

No

Should be ready for Cura using standard ABS settings.

The Dial Indicator I used is from Harbor Freight. Attach the Dial Indicator to the mount. The mount snaps on the edge of the FlexyDually edge, just to the right of the front print head. Tilt the top toward the pack, slide the mount down, then straighten the mount down to snap it into place.