Have you ever thought about a Benchy that can be driven? This is my simple iteration of it. 

I was curious if someone else has ever thought about simply just going through and adding wheels to a Benchy but I only saw really complex versions. In the spirit of keeping the Benchy Benchy-y, I thought this would be fun! The wheels do come off so if you ever wanted to make your own and replace them, go right for it! The wheels also took a bit to start moving easier.

The model is pretty straightforward and it started as a little challenge to see if I could actually model something and it has been fun learning. It was great to go through the same prototyping phase that I'm sure a lot of toy companies have done eons ago.

Printing is not too bad and mine came out on a CR6.

Printed in PLA

0.16mm Layer Height

Supports enabled only for the wheel shaft tips. (I did upload a snip of what that would look like in case anyone was curious.)

With the supports I would just add support blocker for the rest of the Benchy since that should technically not need it anyways.