OctoPi QR code
Gregory3d
AI ile Benzer Model Bul
Baskı Profili(0)
Model Dosyası(0)
0
0
0
Yayınlandı:2025-12-22 13:31:38
1
1
000Açıklama
Etiketler
Model Kaynağı
Yorumlar(0)
I kinda like the QR code on my Ender 3, but it's not terribly helpful going to a mostly Chinese site (generic Creality site) so I decided to put a new QR code over it, one that would pull up OctoPi.Local this way if I am too lazy to type it in, I can just scan it on my phone and begin uploading prints!
I printed out a blank QR code cover https://www.thingiverse.com/thing:3317795, and this QR code, and glues them together. I did this to avoid using supports.
Print Settings
Printer Brand:
Creality
Printer:
Ender 3
Rafts:
No
Supports:
No
Infill:
20%
Filament:
Hatchbox PLAWhite, and Black
Notes:
I set in Cura to pause at a layer (.28mm was layer 25) and switched from white filament to black filament. You really only need a couple layers of black on top for the QR code to work!
Etiketler
Model Kaynağı
Orijinal Link: Detayları Gör
CC-BY