This soap tray is designed to keep soap and excess water off of your countertops.  I designed it to be used in the kitchen (dimensions perfectly fit my place), but it could be used in the bathroom if you prefer.  The cat design is added flair, but lets water trickle down to the base and then drain through the drainage hole.

The base is built with a gradient to allow water to drain through the front hole and optimally into the kitchen (or bathroom) sink.  The plate rests on an internal lip of the base and keeps the soap dispenser off the base floor, allowing space for the water to flow through.

Dimensions: 

• width: 14 cm
• length: 12 cm
• height: 1.5 cm

Print settings:

• material: PLA (Eryone)
• infill: 15%
• No supports needed