When we think about a lamps, we alway are thinking about hanging lamps, bedside lamps and stuff to home decor from an adult point of view. 

I found almost no lamps designed to be used in a kids room, that is why I have created this one.It originally has a tail but for limited space reasons I chopped it out.
I'm sharing here the final version of it.

To make ir I used a PVB filament instead of PLA because PVB is easier to postprocess. Just spray with isopropyl alcohol and let it dry. That is enough to hide the print lines and get that shiny finish it has.

To make the piece hollow, I used Lightning filler at 15%

Nozzle size 0.4mm,

Layer Height 0.2mm,

Print speed 200 ms,

Supports needed to held that big head...

Wall count 2

After print was done and potprocessed, I opened a small hole with a soldering iron so that the light source would properly illuminate the inside of the cat.

I bought the light source on Aliexpress: https://es.aliexpress.com/item/1005004704696970.html?spm=a2g0o.order_list.order_list_main.547.683f194dwdUPEB&gatewayAdapt=glo2esp