This is a remix of touxiong’s Raspberry Pi A/B Mini Classic NES case, published May 1, 2016, his original design can be found here http://www.thingiverse.com/thing:1533740.

With a reduced case size, added memory card slot, replace the power jack with a micro usb breakout board, remove the case screws and replace it with self-locking clips, also there is a fan bracket.

Assembly

You'll need 1 x M2 6mm (No.2 1/4") screws to fix the Raspberry Pi into the case, 1 x M2 6mm (No.2 1/4") screws to attach the usb breakout board to the usb board holder, 1 x M2 10mm to secure the USB board holder, 1 x Paper clip to secure the door, 1 Square 7x7mm Latching Action Mini Push Button Switch and 1 x Square 7mmx7mm Momentary Mini Push.

Use the printed washers to make sure the screws don't penetrate the bottom.

Print Settings

Printer Brand:

Prusa

Printer:

**Rafts:**

No

Supports:

**Resolution:**

0.2mm

Infill:

Category: DIY