An attempt at a simple pot for planting… stuff. Won't win any awards for looks, but is fit for the purpose, reasonably fast to print, can be scaled up and down (scaling below 75% not advised, gets too floppy)… and it is cheap. 100% versions cost about 1.6 EUR in PLA, 75% version about 0.8 EUR. To buy one molded from recycled plastic, in Sweden, would cost 4.6 and 3.2 EUR for similar sizes, so it's pretty economical. Printed with 0.4mm SPEED setting using 0.6mm nozzle. I'm using them for tomato, cucumber pumpkin etc. seedlings so they are not meant to last forever - just long enough. If you need a dozen savings get quite substantial.