When the Sabbatti MMR tactical rifle is fitted with a 56mm scope the cheek piece has to be raised to its limit and sometimes beyond. Depending on calibre this either stops the bolt being fully cycled or prevents its removal without removing the cheek piece first. This cheek piece is higher than the factory one so allows for more up adjustment, it is also cut away at the front to allow for the bolt to travel and be removed with it in place. I have covered mine in 2mm sticky backed neoprene foam rubber for comfort.

I have also included the cover for the original aluminium bar the cheek rest is bolted too.

In addition to the print you will need one M5 x 20mm cap head machine screw and one M5 x 40mm cap head machine screw and one M5 washer to fit the M x 20mm

I have printed this in PLA but I have found ABS or PETG to be a better choice

Print Settings

Printer Brand:

Prusa

Printer:

Rafts:

No

Supports:

Resolution:

.2

Infill:

Category: Hobby