This toothbrush/razor holder, as scaled, will accept a 25mm diameter power toothbrush (like the Oral-B CrossAction shown in the photo). It could be re-scaled somewhat to suit other diameters.

To fit a Fusion ProGlide Styler (a big razor with a trimmer) I scaled the holder to 115%. This is shown printed in blue in the last photo .

It prints without supports. The small top ring piece is printed separately and should be glued on to the top of the spiral stanchions.

Instructions

Print then invert the top ring, and glue it on to the spiral stanchions. It will only slot in to place in the correct orientation.

[Note: I had some issues with the over-hanging edges of the stanchions when printing on my Printrbot in PLA with 0.15mm layers. I switched to 0.3mm layers and the edges cleaned up nicely.]