This is a slight modification on the Yet another servo driven fpv tiny tank by Ultrawipf.

I have a bunch of 600mah batteries and they didn't quite fit inside, so i made a new base that had a little bit more room above the servos, and a channel through the middle for cable management.

My base is just a hair longer than the original, so there is a slight lip, and I didn't get fancy with the servo opening like the original and contour the edges.

It is otherwise the same.

I am using 0.25oz tire weights to give it a bit more bottom heaviness so it can climb a bit better, and lift a bit more with the shovel.

• weight on the shovel helps with throwing your balance around as you go over stuff
• weights between the tracks helps with crawling
• weights on the back help with flipping things (but detracts from crawling a bit)

This thing is a blast to play with! thanks to Ultrawipf for creating such a cool little tank.

Creality

Ender 5

Yes

0.12

20%

Original instructions remain:

• Print shovel on side with supports everywhere
• Top Cover print upside down with supports

Chassis: print right side up, with supports for nice clean angles