There are two options, a bed that can fit an already printed Buddy, and a bed with Buddy already inside. (The Buddy already in the bed is not removable)

This is a dog bed for Buddy. I felt the model needed an accessory so I modeled this in blender. Buddy should just snap into it. If he doesn't, sand the walls of the bed a little. The bed is a tight fit so you may have to wiggle Buddy a little to remove him.

Print Settings:

Infill: 25%

Resolution: 0.1mm

Supports: No

Rafts: Doesnt Matter

Filament Used: Polymaker Polyterra PLA