I was given a moon lamp and wanted to display it, so designed this shelf in Tinkercad.

I wanted the wheel / bracket to be 3D, so split the bracket in half so I could print without supports then glued them together, prior to gluing them to the shelf.

I only put two holes in for attaching to the wall but should have put four holes for better attachment. In the end I just used the Command 3M strips to attach to the wall since the lamp is not heavy.

Print Settings

Printer Brand:

FlashForge

Printer: 

Adventurer 3

Rafts:

No

Supports: 

No

Infill:

20

Filament: Flashforge PLA white 
 

Notes: 

you can just tell from the photographs that I finished one filament on the brackets and started a new one, so there are different shades of white.
You might also notice that there is a little curling in the prints which I need to fix up.

Category: Decor