Raspberry Pi 4 Case
pixel_creator
AI ile Benzer Model Bul
Baskı Profili(0)
Model Dosyası(0)
0
0
0
Yayınlandı:2020-12-07 04:24:12
0
0
000Açıklama
Model Kaynağı
Yorumlar(0)
Summary
Snap fit Raspberry pi 4 case, no screws necessary. Basically a honeycomb venting style design. There' s 3 types of tops. 1.) No slots or cutouts. 2.) Top with slots cutout. 3.) Top with slots punchouts that can be removed when needed.
The Raspberry pi 4 runs very hot and should be used with heatsinks on the chips. This minimal low profile design should be able to accomodate the heat sinks. I did not design a type with a vent or fan screw holes. The case is vented enough without a vent design. If one is sole desired I can add it upon request
Print Settings
Printer Brand:
LulzBot
Printer:
TAZ 6
Rafts:
No
Supports:
No
Resolution:
Any Desired
Infill:
Any Desired
Model Kaynağı
Orijinal Link: Detayları Gör
CC BY