Very simple and fast printing cable guide that will keep the extruder and hot end cables out of the way of your z-axis rods.

If you don't want to commit to a chain link guide just yet or just want something that prints super fast (<20min with Cura at 0.2mm), this will keep the cables out of the way and avoid them getting trapped between the extruder and the Z-block or interfering with the end switch.

It snaps on to the fan plate and can be secured with the existing fan screw.

The tabs are admittedly not very strong because of the direction of print, but you can reinforce them with zip-ties if you wish.

Print instructions

Rafts: No
Supports: No
Resolution: 0.2mm
Infill: 30%