This is a desktop holder/lamp for a single curved lithophane. Please ensure you print your lithophane using the settings provided in the screenshot and in the notes section otherwise it will not fit. If you have any questions please let me know!

Artillery Sidewinder X-1

No

Yes

.2

20%

To ensure proper fit you must select an image that is wider than it is tall (Landscape orientation) and use the settings in the provided screenshot when creating your Lithophane on: http://3dp.rocks/lithophane/

Important settings are as follows:
Maximum Size: 254mm
Thickness: 3mm
Border: 3mm
Curve: 90

Once printed to complete assembly you will need standard piece of all thread roughly 25mm in length and 9.8mm diameter, a couple of appropriately sized all thread nuts, a lamp socket, and a lamp cord (all of which I sourced at my local hardware store for roughly $20). I would recommend sticking to only using LED light bulbs as incandescent will generate too much heat. I found a 60W replacement bulb with a 'daylight' color temperature worked quite well.

If you have any questions don't hesitate to contact me!