Labradar stand for keeping your precious radar from falling over.

Update 2022-02-15
Plate2 has been added to save on weight and material.

Needed hardware
Some 1/4 20 NC threaded rod (screw) for attaching the radar to the plate. A nut for tightening the stand against the radar.

I got some 6 mm brass rod. Turned M6 threads in one end, and 1/4 20 NC in the other. I glued a wingnut on to the M6 end, and stuck it through the hole in the stand. Tight fit is enough to keep it there, but depending on you tolerances, you may need add a containing clip.

Optional hardware
The stand has holes for 5 x M5 nuts. These can be glued in place, and upside down screws can be used to level the stand. If standing on a flat surface, the 4 nuts in the corners can be used. If standing on an uneven surface, use 2 in front and 1 in the middle on the back, for a 3 feet platform.

Anycubic

All-metal Mega

No

No

0.2

25%