Lock tab guide for RX7 FB (1979-1985)

V1:

• Print at 45 degree angle for best strength
• This version is a lot tighter on tolerances but if you have a precise printer and a clean cutout on your door, I should fit.(I could not make it work on my car because of other factors but the measurements are following the original piece that was present on the car.)
• The shape is not the exact same as original, it has straighter edges.

V2:

• The part differs slightly from the original part where the locking mechanism is a friction instead of a “lock tab”. This style is more forgiving on the material type used and so, less flexible material can be used to hold this guide down. For example, I use pla+ and it holds up well.
• This version is slightly curvier than original but it is not really noticeable and, in my opinion, looks better. Will make a truer to original version if enough people show interest in it.