Remote rack based on Celtic drawing.

I3 Mega

No

No

0.1, 2 shells

20%

The model is based on a drawing. As a result it's asymmetrical. Pay attention to the part orientation.

• As a rule of thumb, all the "printing-bed" side of all the parts will face out.

i. Start with "front", "left" & "right".

ii. Slide "left" & "right" all the way into the slots in "front".
The stopping knob on "left" & "right" should face up and inward.

iii. Slide "left" & "right" into the slots in "frame".
Do not slide them all the way in.
You should leave the lower slot in "front" clear.

iv. Slide "bottom" in the slots of "front" and "frame".
v. Slide "left" & "right" all the way down, and lock "bottom" in place.