This rocket is meant to be flown with an 18mm motor and an 8 or 9 inch parachute. The engines that can be used are: B4-4,B6-4, and C5-6. The rocket should fit on a Prusa mini or bigger printer. print the nose cone sideways and the rocket upright. Print at 10-15% infill with 0.20mm layer height. use an elastic shock cord to connect and nylon parachute. There is a small hole at the bottom of the rocket to glue on a motor retainer, use hot glue or epoxy to glue it on

WARNING: DO NOT GLUE ON NOSE CONE THE ROCKET WILL EXPLODE.