Here is a replacement for the front bumper assembly for the r/c car FTX Bugsta (also fits the FTX Outlaw and FTX Carnage). It includes the bumper and the support bracket in two variations. You only need to print one of the two support brackets. (It is the same as this thing.

Can be printed in PLA as well as ABS. if you go for ABS, use support and ABS slurry on the bed to prevent warping. PLA can be printed without support , but i'd advise to use support always. ABS seems more durable, but is a bit harder to print, especially with the support.

extra note: I recommend you use 100% infill around the base where it bolts to the chassis. I have empirically established this to be the weakest point ;-). Best leave infill elsewhere at around 50%.

FTX part number it replaces: FTX6324

Enjoy!

Prusa

i3 MK3

No

Yes

0.20

50%

Print in either PLA or ABS. Best with supports.rnUse infill of 50% or more. Use ABS Slurry on the bed when printed in ABS.rnPrint with front side facing down