Wanted a box to stop my speed stitcher, needles and bobbins rattling around in the bigger toolbox so decided to make this.

It fits into a large Stanley Fat Max tray, but it's not a tight fit so it can be lifted out when needed.

It will hold 4 bobbins, plus the one in the Stitcher itself and there's a slot for spare needles too. So should be enough for most people.

If you want it more secure (for storing on a boat, truck or trailer) Just use an elastic band!

Print Settings

Printer Brand:

Anycubic

Printer:

Rafts:

Doesn't Matter

Supports:

Resolution:

0.3mm

Infill:

Notes:

I print at the slightly slower 50mm/s vs 60mm/s for good adhesion and cleaner lines.

Post-Printing

You may need to do a little work on the lid mounting pins. At 0.3mm the holes needed opening a little and some light sanding on the pins themselves. At a finer resolution this probably isn't necessary but it was 2 minutes of dressing vs an extra 4 hours of printing.

Category: Tool Holders & Boxes