This is to be able to use 18650 batteries in a Streamlight stinger. It two pieces for loand in unloading the 18650.

If there is trouble printing the holder right side up print it upside down with supports. Infill on spacer can be lower. For XTs need a rod 7mm by 61mm inside the spacer. For others will need to make a wire loop for the top and feed the wire down the channel and bend over the bottom of the 18650 using the spacer to hold it.

Print Settings

Printer:

Monoprice Maker Select

Rafts:

Supports:

Doesn't Matter

Resolution:

Infill:

50