Heavy Duty Wall Hook
Marcus Silva
AI ile Benzer Model Bul
Baskı Profili(0)
Model Dosyası(0)
0
0
0
Yayınlandı:2026-02-24 02:07:43
0
0
000Açıklama
Etiketler
Model Kaynağı
Yorumlar(0)
Simple wall hook with hole marker. Just push in the top of the guide to set it in the sheetrock, then use a level to get it just right, then push in the bottom part to make the holes you need to drill for your wall anchors.
Unsure of actual weight it can hold, but I pulled on it pretty hard and it didn't budge at all. Assuming you have your printer printing right, and using a decent filament, you should be able to hang pretty much whatever on these.
Print Settings
Printer Brand:
Creality
Printer:
Ender 3 Pro
Rafts:
No
Supports:
No
Resolution:
.2
Infill:
I used 60% for strength
Filament: dealer's choice PLA+ or better
dealer's choice
Notes:
If you don't care about layer lines, you can go with a wider nozzle and layer height to make it print faster. Also increase number of perimeters to increase strength. I used 5 perimeters on my prints.
Etiketler
Model Kaynağı
Orijinal Link: Detayları Gör
CC-BY