This is my own version of "Car Roof Bar Rack Crossbars Mount by jschaftenaar".

It is basically the same idea but with following changes :

1) 4 screwholes intead of 2.
2) Base naworrer -adapted to my Thule's Wingbars Evo´s size.
3) Full piece a bit smaller due to limited bed size of my Ender 3 v2.
4) A little wider/stronger to compensate the fact that now is the piece is narrower.
4) Rounded / nicer edges.

On my Ender 3 v2 I had to remove the safe limits following this tutorial : https://www.youtube.com/watch?v=Il1sierB4Yk otherwise wasn't posible to print it flat.

Happy printing.

No

No

200

As high as possible.