i wanted something to mount the k1 camera inside my vorons so i designed this mount to connect to the top of the printer extrusion to ensure the camera was out of the way for monolith awd.

the k1 camera is 1080p 30fps and can handle a 70c chamber once a heatsink is stuck on it, its also a standard usb camera and works with the pi cm5 without any issues.
you can use a tmc2209 heatsink on the camera chip. 

mounting re-uses the stock screws, a single m3 t-nut and an m3x8.

printed facing camera side down with 0 supports.

required bom:

• m3x8 shcs x1
• 2020 series m3 roll in t-nut x1
• camera cable (double check the pinout, check pictures)
• Creality k1 camera
• tmc2209 heatsink (optional)
  
  please keep in mind the camera pinout, the cable listed will likely ship with the incorrect pinout. it should match this: