XT60 connectors are sometimes hard to disconnect and can be even fingers hurting.
I designed this XT60 grip to improve the grip, thus help disconnecting with fewer finger pinching force needed.
This single part fits either male or female XT60 connector. Work only with the common "rectangular" standard connector, not the model with gray cover (see photo).
Fitting subject to XT60 manufacturer tolerances, may fit more tight or loose depending on the manufacturer...
I hope you will enjoy it.

No support needed for printing, the needed support is integrated to the 3D model.
Just simply pop out the support by pushing it inside the part, and tear off the the remaining pieces if necessary. The support will break clean along the inner retaining edge of the part and let it clean. No other post processing needed.