Need to get your table surface clean and clutter-free?

Just mount all that USB stuff under the table!
 

For easier mounting apply some double-sided tape to the holder. 

Then do a test fit, and secure with two 3mm screws.

To clear the cable this mount only covers a part of the UCA222 and leaves all connectors etc 

accessible. 

This model is made with FreeCAD - it is parametric, just change the desired parameters in the “dims” spreadsheet in the spreadsheet workbench.

Print with material of your choice. I used PLA with 0.2mm layer height, 20% infill. 

No supports needed, be sure to use a brim for good build plate adhesion!