Print at 100% infill with a layer height of 0.08mm with a base layer of 0.16mm

 The Model is 200x200mm in size. You can change X and Y but Z must remain the same.

 You may print at higher layer heights below the Min Depth of 0.48mm

 Actual Depth is 2.3mm

Filaments Used:

PLA BambuLab Basic Purple Transmission Distance: 2

PLA BambuLab Basic Pink Transmission Distance: 8

PLA BambuLab Basic Black Transmission Distance: 0.6

PLA BambuLab Basic Jade White Transmission Distance: 5

This print uses 4 unique filaments. Substitute as needed.

Swap Instructions:

Start with Purple

At layer #6 (0.56mm) swap to Pink

At layer #14 (1.2mm) swap to Black

At layer #19 (1.6mm) swap to Purple

At layer #21 (1.76mm) swap to Pink

At layer #25 (2.08mm) swap to Jade White for the rest.