Note: This Print is for the Snapmaker 1.0 which I don't have anymore.

Part cooling fan holder for 2x 40mm fans. Connect with 2x M3x16mm screws to

https://www.prusaprinters.org/prints/99879-snapmaker-accessory-mount-goes-nuts
or
https://www.thingiverse.com/thing:2816454

then it will cool your printed part.

Print Settings

Printer:

Snapmaker

Rafts: 

No

Supports:

Yes

Resolution: 

.2 layer height

Infill:

15%

Notes: 

Print it flat on the mounting plate part. You would only need two small support towers for making the screw hole nicer, but you can even print it without support if you don't care about that.

Walls optimized for .4 nozzle.

Category: 3D Printer Accessories