This is a very simple replacement knob or drawer pull for a wooden style knob. this is styled to be similar in appearence to the more and more common fabric dressers being sold on amazon like this-- https://a.co/d/fNlGmGa the replacement knob should be printed with 3 walls at least and have a pretty rugged infill like cubic or adaptivecubic. Remember this thing is gonna see some use! Higher infill is recommended so it doesn't pull apart in your hand.

The model has been pre-oriented to have no more that a 45-50 degree overhang, no support needed.

You will need to use the old threaded inset if your knob pulled off like mine did. if you've lost the knob entirely you will need to get one from your local depot/lowes/ace, whatever is in your region. you will need to match your own thread pitch as they do vary. The most common used is for a #8 thread though.  

Use the heat set method to install your insert, this cannot be press fit if you expect longevity. 

Printed in PolyTerra Earth Brown

• 3 walls + 50% adaptive cubic
• No support / pre orientated
• Threaded insert needed