The source design by Gnattycole (thank you) was the only mount I could find for the 85mm diameter Neopixel 24 LED ring.

I trimmed off the printer specific duct parts leaving just the ring - and added some extra cutouts required to fit the LED ring I have - and increased the thickness of the base to keep the wires/contacts further away from the metal I mounted it to.

Its now mounted in this holder to the underside of the top of my FLSUN SuperRacer.

I have an SKR 1.3 mainboard, and are using the unused "servo" header PIN 2.0 for the NeoPixel Data.

Category: 3D Printer Parts