Storage Box

Printed with a roll of inexpensive PLA I bought during a flash sale for €10, this storage box consists of 30 storage compartments arranged 5 rows by 6 columns (30x30x30mm) in one solid print. It uses quite a bit of filament so I would not use premier filament on it...

I will also add individual storage boxes that can be arranged and printed as needed, I tend to print these as test prints when testing new filaments that way I get some useful and colorful storage boxes that can be combined to produce a storage system (just print an outer shell to hold them)...

Creality CR-10

No

No

0.3

20%

Even PLA will warp with large prints so you might want to increase the bed temperature...

The filament I used was purchased from LightInTheBox but arrived unbranded, this is a shame as it was only €10 in a flash sale and was perhaps the best PLA I have ever used... not even a single string which is important when printing such a design as it has lots of areas where stringing is common...

Printed at 200/70 ℃ (bed was set to 70 ℃ to help avoid warping which I suffer from with all filaments) ;(