Small AFG for Keymod rail, Odinworks inspired. Small but comfortable for a good hand angle if using a thumb over bore grip.

I could only get it on with just the rear pin in place with the keymod screws i had which seemed short. It is still on there very solid.

Print laying on its side with support only for 80 degree overhangs. I used PETG and .2 layer at 55mm per sec, 30% infill in Cura.

Print Settings

Printer:

Anet A6

Rafts:

Supports:

Yes

Resolution:

Infill:

30

Notes:

Category: Sport & Outdoors