I made these over a year ago I wasn't going to post them due to me thinking there wasn't a need. They are a one time use as they currently full into the slot when the ride is over.

FlashForge

Dreamer

No

Yes

0.3 MM

Angle the tokens at 45 degrees to save time and support filament. You can print multiple but keep in mind if your printer isn't level there is a chance of a fail print.

1. If you want a more accurate token increase resolution and maybe use ABS and acetone for a smooth surface finish
2. Try use same colour as originals
3. Just for good measure use a zero knife to clear the middle hole.