Pegboard holder for Centech 61593 multimeter
Ethan Nyberg09
AI ile Benzer Model Bul
Baskı Profili(0)
Model Dosyası(0)
0
0
0
Yayınlandı:2025-12-27 09:28:00
0
0
000Açıklama
Model Kaynağı
Yorumlar(0)
I needed a pegboard holder for my Centech 61593 multimeter. It's nice for the price (I got it at Harbor Freight) but too bulky to fit in any of the existing multimeter pegboard projects I found. It would also make for a decent 'cup' for many other boxy items.
Print Settings
Printer:
Prusa i3 Mk2
Rafts:
No
No
Resolution:
200um
20%
Notes:
The cup's bottom is chamfered with a 45° overhang, so it shouldn't pose a problem to print.
I printed the backplate on its side with no support material. the bend in the hook is apparently gentle enough that the overhangs weren't a problem for my printer.Your mileage may vary.
Post-Printing
Slide the baseplate into the back of the cup. There's .5mm of tolerance on each side, so add some glue if the pieces don't fit together as snug as you'd like, or sand the sides down if they're a little too snug.
Category: Tool Holders & BoxesModel Kaynağı
Orijinal Link: Detayları Gör
CC-BY-SA