Print time is more or less around 3h6m at 0.16 layer heigh (0.4 mm nozzle).

Print parameters:

• Layer height - 0.16mm
• Perimeters - 3
• Infill - 10% is sufficient (infill lightning)
• Brim - NO 
• Support - NO
• Raft - NO
• Filament type - PLA or any
   

Could be printed even in multicolor without MMU, AMS or similar.

For multicolor print:

When printing at 0.16 layer height: put the printer in Color Change mode(G-code M600) at layer 30 and then change filament
When printing at 0.2 layer height: put the printer in Color Change mode(G-code M600) at layer 25 and then change filament

You can increase dimmesions at will but pay attention if you want to print in multicolor, this will change the layer number when you must put the printer in Color Change mode(G-code M600).