While upgrading the antennas on the GoFilm20 with TrueRC Singularity antennas i needed to make something that would hold them in place a bit better so they don't flop over.

I created this small brace intended to surround the antenna cable and hold it as high up as possible.

Print in TPU, and slide it into the stock openings. I trimmed down the top edge a tad for the length of antennas i had, you may or may not need to do so

Placed flat on the bed it should be printable without supports.

• Printer: Prusa CoreOne
• Filament: Overture TPU
• Infill: Default (15% - doesn't matter)
• Supports: No
• Orientation: long flat edge down