Cable support for standard 3D printer stepper motors. Provides an anchor point for securing wires from or near the stepper.

Simply unplug the stepper motor cable and slide on the support being sure to align the notch with the motor's connector. Next plugin in the cable and secure with a zip tie.

My stepper motors barely get warm so PLA works just fine. ABS or a higher temperature resistant filament may be needed if yours are hot to the touch.

A 10mm thick version is included for shorter motors.

Split versions are also included to allow installed without removing the motor or cable. Notched versions to provide more clearance for some steppers.

If these don't work with your stepper, send me a note and I can look into making adjustments.