This is a case I designed for PI KVM setup that has a feature for a DB9/Serial port for routing GPIO out of the case. No hardware is needed, it should snap together.

Updated the front/bezel part as the feature that holds the HDMI-CSI board as it had a weak point.

For stronger snaps and a better finish, it is best to print with the back of the top and bottom parts on the build plate.

07-31-21 Added the latest revision of the Fuson360 files

08-01-21 Added a not DB9/Serial version of the top

This is the HDMI to CSI2 board that I am using https://bit.ly/3lhPbe8

Print Settings

Printer Brand:

Creality

Printer:

Rafts:

No

Supports:

Resolution:

200

Infill:

Filament: Overture PETG

Category: 3D Printing