Created some parts to turn  https://www.printables.com/model/557480-classic-lantern

into a street light for a New Orleans themed birthday party.

Non-printed parts required:

1. 1 ½ inch PVC (plumbing section) for the pole
2. 4 inch PVC (plumbing section) for the base
3. ½ inch PVC (plumbing section) for the sign poles
4. 1 ½ inch PVC (plumbing section) pipe cap
5. 3 or 4 cheap shelf brackets for the base feet
6. Battery powered flickering candles ( https://www.amazon.com/dp/B07D54VFZN?ref=ppx_pop_mob_ap_share )

Printed parts not included in this file:

1. https://www.printables.com/model/557480-classic-lantern

Printed parts included in this file:

1. Single candle holder
2. Double candle holder
3. ½ PVC end knobs
4. 4 inch base top
5. 4 inch base bottom

Instructions:

Printed everything in Overture PLA Professional (or PLA+). .2 layer height and used supports for the candle holders and knobs. 

Candle holders designed for these candles: ( https://www.amazon.com/dp/B07D54VFZN?ref=ppx_pop_mob_ap_share ).

Used 1 small screw through the candle hold of choice, then the lantern bottom and into the 1 ½ inch PVC cap. Cut the 1 ½ inch PVC to desired length. Slide the base top up from the bottom of the 1 ½ inch pole, then the 4 inch PVC and finally line the 1 ½ inch pole up with the insert on base bottom piece and push all together.  You can glue or silicone the base to the bottom and add sand or other medium to add weight if desire. Mine was fine without it. Then screw 3 or 4 of the shelf brackets to the base for support. It did stand on its own but I added the feet to make it more stable outside.