Yet Another ATX Conversion
magicorbit
AI ile Benzer Model Bul
Baskı Profili(0)
Model Dosyası(0)
0
0
0
Yayınlandı:2015-10-21 16:46:54
0
0
000Açıklama
Model Kaynağı
Yorumlar(0)
Summary
Thingiverse is full of ATX-to-general-PSU conversions. Why I created another one? Because I did not want the outputs directly on the ATX PSU. I want them on separate box connected to PSU by cable.
Print Settings
Rafts:
No
Supports:
No
Post-Printing
Mechanical setup
The box is held together with four M4x40 screws with socket heads.
Electrical setup
There is lot of instructions how to convert ATX PSU to general purpose one. For example this on WikiHow. So, I provide just a quick cheat sheet on wire colors:
- Black = ground
- Yellow = +12 V
- Red = +5 V
- Orange = + 3.3 V
- White = -5 V
- Blue = -12 V
- Gray or Brown = "power good" signal +5 V; connect to LED trough 330 ohm resistor and to the ground
- Green = on/off; connect to ground trough power switch.
Model Kaynağı
Orijinal Link: Detayları Gör
CC BY