Electric Guitar model based on Dean "Dime from hell" STL file is more or less 1:1 scale. For printing I've used 0,35 scale factor, in my opinion it give best results. 0.2 layer for body and 0.1 layer is ok.

To avoid supports, neck is divided in 2 pieces for easier printing. Neck head is flat, so it's good to bend it a little bit using heat.

Check out my other designs:

Ibanez Jem – https://www.thingiverse.com/thing:5026320

Bc Rich Warlock – https://www.thingiverse.com/thing:5103842

Ibanez Iceman - https://www.thingiverse.com/thing:5231125

Fender Stratocaster - https://www.thingiverse.com/thing:2748193

Fender Telecaster- https://www.thingiverse.com/thing:4056363

ESP Explorer - https://www.thingiverse.com/thing:2746802

Gibson Flying V https://www.thingiverse.com/thing:2747925

Gibson Les Paul - https://www.thingiverse.com/thing:2839766

PRS Mark Tremonti - https://www.thingiverse.com/thing:3421690

Gibson Sg –https://www.thingiverse.com/thing:5350017

Dean Rebel – https://www.thingiverse.com/thing:5359480

Jackson RR - https://www.thingiverse.com/thing:5437801

Post-Printing

Category: Music