Sanding Pencil
PeachOasis
AI ile Benzer Model Bul
Baskı Profili(0)
Model Dosyası(0)
0
0
0
Yayınlandı:2026-01-08 08:29:24
0
0
000Açıklama
Model Kaynağı
Yorumlar(0)
I found that when I was using my finger to sand a spot on my guitar today that it was getting in the way and I couldn't see what I was working on.
This is a two sided pencil. I cut a strip of sanding paper to wrap around the end and I held it tight with my fingers as I held the pencil. You could also use a rubber band or other fastener.
Print Settings
Printer Brand:
Creality
Printer:
K1
Rafts:
Doesn't Matter
Supports:
Yes
Resolution:
.2
Infill:
10%
Filament: Any PLA Any
Notes:
Should be a pretty easy print. I used tree supports for the nub on the end and it worked flawlessly. Took about 6 minutes to print on my K1.
Model Kaynağı
Orijinal Link: Detayları Gör
CC-BY-SA