A hard case for the NetAlly LinkSprinter LS300 Pocket Network Tester. I bought mine used so it didn't come with the soft protective cover. I hope to improve on the original soft cover by including a space to store the two AA batteries outside of the LinkSprinter which will eliminate the risk of them leaking inside and corroding the electronics.

Assembled case dimensions: x: 58mm y: 160mm z: 38mm

The photos show the actual printed parts in eSUN PLA+ (Peak Green):

• 0.4mm nozzle
• 0.2mm layer height
• 3 Perimeters
• 20% Inflill
• Supports: No.

Parts required for assembly:

• Print 1x Base
• Print 1x Top
• Print 1x Clip
• 4x 5mm x 50mm bolts and nuts - 2x for the hinge and 2x for the clip. I recommend locking nuts or thread locking glue so they don't loosen when hinging the case open and closed.