Do you buy Prusament filament?

Do you buy samples?

Do you have nowhere to put your samples?

Then rejoice the solution is here

Prusament comes on a 3 part spool with 2 sides and a cardboard central tube

See more here

https://www.prusaprinters.org/prusament-spools-reuse-ideas/

if you are careful you can pull the spool apart to give you two sides

If you then print this then you can press it onto one of the sides to give you a smaller sample spool holder

NOTE

The model shown in the pictures has a honeycomb pattern on the side

This is done by switching off the top and bottom layers while turning the perimeters up to 5

UPDATE

I have added version 1.2 which has a bigger chamfer and a hole for the end of the filament

And a Fusion 360 design here https://a360.co/2UE7f4Y

Print instructions

The model shown in the pictures has a honeycomb pattern on the side

This is done by switching off the top and bottom layers while turning the perimeters up to 5