Deck Board Spacer / Hole Guide
Gerald Aho01
AI ile Benzer Model Bul
Baskı Profili(0)
Model Dosyası(0)
0
0
0
Yayınlandı:2019-03-28 11:25:13
0
0
000Açıklama
Model Kaynağı
Yorumlar(0)
Summary
I was building a wooden deck using 5/4 deck boards and 2x framing and wanted a jig that would make for a consistent board gap as well as insure that my screws are in a nice straight line. This was my idea. The holes are counter sunk to allow for a drill chuck to bottom out without damaging the guide. The flat tab is a 2mm spacer that will go between the boards and the forked sider will fit over the frame material. Enjoy.
Print Settings
Printer Brand:
Wanhao
Printer:
Wanhao Duplicator i3 Plus
Rafts:
No
Supports:
No
Resolution:
0.2
Infill:
50%
Model Kaynağı
Orijinal Link: Detayları Gör
CC BY